Roof valleys often lead to excessive rainwater flow and debris accumulation, posing challenges for gutter guards where the roof valley meets the gutter. The BRAND Insider Miter accessory is a versatile solution designed to complement BRAND gutter guards in these high-flow areas
The Features
Pre-cut for flexible and easy installation
Made with 8 Mesh Stainless Steel Micro-Mesh and extruded aluminum rails for superior water flow, strength, and durability
Fits most roof types: Asphalt, Flat Tile, Spanish Tile, Villa Tile, Stone Coated Steel, Corrugated Steel, Standing Lock Seam, Wood Shake, Membrane, Flat Roof
Compatible with most gutter guard technologies and products
Please click the images below to view more information:
To install the fascia mount at a consistent height, we recommend cutting a 2x4 piece of wood the same depth as the gutter to use as a guide.
Using the indent scribe as a screw guide, attach the fascia mount (with the drip edge down) to the fascia.
Use 2 screws for each 6 inch piece, or 4 screws if installing a full 4 foot piece of gutter guard fascia mount.
1. Use 1 piece of 6 inch fascia mount as a center support for a 4 foot piece of gutter guard, and then 1 piece of 6 inch fascia mount at both ends.
2. The 6 inch end pieces should be installed where they support the last 3 inches of gutter guard and then allow 3 inches of support for the next gutter guard installed.
1. Rest the rear of the gutter guard on the fascia mount. The top side of the fascia mount is tapered at a slight angle and will support the gutter guard.
2. If necessary, the gutter guard can be fastened to the fascia mount with screws. Follow the gutter guard installation steps